THE DIY CAR STOP

Park your car in exactly the right place every time with Big Al's Car Stop! Ideal for garages where parking space is limited.

 

Manufactured from tough PVC, this easy to install product is guaranteed to last. The bright orange line in the middle was specifically chosen to ensure your safety - once placed on the floor this strip is noticeable to your peripheral vision ensuring your awareness against tripping or falling.

 

A specialized sealant is provided, which in conjunction with our serrated, grooved base ensures an easy installation that will last for years to come.

Easy Installation Instructions

 

Download our printable PDF instructions here.

 

Important Note Before You Begin:

It is always important to plan your installation beforehand. 

1. Measure & Mark

  • Drive the car to your desired parking position in your garage.

  • Place the Car Stop Strips in front both front tires

  • Reverse your vehicle and using a soft pencil, mark the floor around the Seal so when you remove the Seal you know where to stick the masking tape. At this point, make sure the seals are positioned in a straight line.

2. Preparation

  • Place masking tape on all four sides of each Car Stop Seal

  • Clean and dry the area where you plan to install the Car Stop. Use benzene, thinners or alcohol to ensure a clean bonding surface. All dirt, water, mud, oil and other debris must be removed. (NB: Use personal protective equipment when using chemicals - gloves, masks, glasses etc.)

  • Apply the adhesive to the floor between the lines using zigzag lines.

3. Installation

  • This step is very important! Push the strip onto the adhesive starting at one end slowly forcing out air bubbles as you push the strip down.

  • Once the Car Stop is in place, run a bead of adhesive along the edge of the Car Stop. Use your finger or a cloth with soapy water to smooth out the adhesive before it starts to set. We recommend putting masking tape on the Car Stop Strip before running the bead to ensure a neat finish.

  • Remove the masking tape before the adhesive sets. Wipe any excess adhesive with a cloth and lacquer thinners

This is a trully remarkable product that will make your life so much easier!

© 2011 Big Al Trading (Pty) Ltd.​ Proudly created with Wix.com

Straight

Ensure the strips are in a straight line